DENALI Smart Controller Dialdim

Lighting Controller DialDim™

Provides a complete solution with easy control of all lighting functions.

• Turn on/off and independently dim two additional lighting sets from a single switch.
• The LED halo switch displays your exact settings.
• Unlock smart flash functions that can cancel your auxiliary lights with your indicator, make your auxiliary lights flash like an indicator, or make your lights flash when you honk the horn.

On/Off & Dim
Independently control two sets of on/off lights and the intensity level using the DialDim™ switch. The blue halo controls lighting set 1 and the green halo controls lighting set 2. Double-click to switch between the two circuits.

Up/Down Synchronisation
Your auxiliary lights will automatically switch from your current setting to full intensity with the original high beam switch. Simply connect the blue input wire to your vehicle's high beam circuit to enable this function.

Stealth Mode
A smart setting of 0% brightness on the switch allows your lights to be off under normal driving conditions, but they will switch to 100% intensity with your vehicle's high beam switch. In this mode, the lights also respond to indicator signals and the horn, but remain off when not detected.

Cancellation with Indicators
When activated, the main lights (circuit blue 1) turn off in sync with your original indicator. Just connect the yellow and orange input wires to your vehicle's indicator circuit to enable this function.

Flash as Indicator
When this function is activated, your lights (circuit green 2) will flash in sync with your original indicators. Simply connect the yellow and orange input wires to your vehicle's indicator circuit to enable this function.

Strobe with Horn
When this function is activated, the auxiliary lights from both circuits flash at 4 Hz when you honk the horn. Just connect the green input wire to your vehicle's horn circuit to enable this function.

Electronic Fuse Circuits
Both lighting circuits are electronic fuse and can be reset directly from the switch itself! The halo lights up red to warn you of a triggered circuit fuse.

Voltage Indicator
When starting the vehicle, the switch halo flashes green to indicate a healthy battery voltage, or red to indicate a battery voltage below 11.8 volts.

Low Voltage Cut-Off
If the battery voltage drops below 10.8 V, the lights do not turn on, preventing you from getting stranded. The switch halo flashes 4 red LEDs to indicate a low voltage condition.