RFX Motorcycle gas cylinder Pro Series Fantic XX 125

.

Pro Series Throttle Sleeves

The RFX Pro Series throttle tubes are machined from billet aluminium and feature a sealed bearing and a Teflon sleeve to operate the throttle effortlessly. The RFX Pro Series tubes withstand damage in a collision, unlike standard plastic tubes. For these reasons, they are used by many racing teams and top riders in British championships, such as STR KTM.

• Replacement throttle tubes for all well-known off-road bikes.
• Uses the same cam profile as the original part for good throttle control.
• Construction from hard-anodised billet aluminium.
• The sealed ball bearing and Teflon sleeve virtually eliminate any friction.
• RFX logo laser-engraved.
• Grooved grip mounting area.
• Reduced risk of damage in case of an accident.

Slogan

Roller Bearing

For effortless throttle operation

CNC Machined Construction

For maximum impact resistance

Installation Instructions

• Slide the rubber sleeve down and dismantle the throttle housing, removing the old throttle tube while being careful not to damage the throttle cables.
• Gently remove the grip from the old throttle tube if necessary.
• Check that the cables and housing are not too damaged or worn; clean and lubricate them or replace if necessary.
• Clean the handlebars and check for damage where the old throttle tube has turned on the handlebars; if there are any rough edges, replace the handlebars.
• Slide the new throttle tube onto the handlebars and lubricate it with a penetrating lubricant, preferably Maxima MPPL (do not use grease as it attracts dirt and can make the throttle stick after a short time).
• Reassemble the throttle cables and housing using a penetrating lubricant.
• Tighten the throttle housing into the correct position on the handlebars.
• Adjust the cable play to your preference.
• Turn the handlebars to their maximum position to check the proper operation of the throttle and the correct routing of the cable; some cable readjustment may be necessary.
• Slide the rubber sleeve over the housing.
• Cover the opening at the end of the grip with electrical tape (to prevent the glue from entering the throttle barrel) and apply a small amount of special grip glue RFX to the outer end of the throttle tube, on the outer diameter.
• Apply a small amount of special grip glue RFX inside the new grip and slide it onto the tube.
• Turn the grip into the correct position and let it dry.
• Apply brake wire for grips RFX if necessary.
• After the glue has dried, check the throttle operation again.

Specifications:

• color: Black
• material: Aluminium
• v-color: Black
• weight (g): 70
• width (mm): 100
• height (mm): 50
• length (mm): 140
• volume (cm³): 700
• packaging: single unit