RFX Rear wheel spacer for motorcycle Honda Pro Series

The RFX Pro Series wheel spacers are lighter and more durable than the original parts.

Made from 7075-T6 aluminium and anodised in colour, they resist surface wear and limit dirt entry into the hub, extending the life of the bearings.

A rear shoulder keeps the spacers attached to the seals, preventing them from falling off during maintenance and speeding up wheel changes.

Features:

• 7075-T6 aluminium construction
• Colour anodisation for wear resistance
• CNC machining for reduced tolerances
• Rear shoulder to hold during maintenance

Installation instructions:

1. Place the motorcycle on a bike stand, with the wheels off the ground.
2. Remove the large axle nut and loosen the pinch bolts at the bottom of the fork clamp.
3. Remove the wheel axle; a brass punch and hammer may be needed if the axle is stuck.
4. The front wheel can then be removed.
5. The rear wheel should be free enough to push forward and release the chain from the sprocket.
6. Remove the rear wheel.
7. Take off the wheel spacers.
8. Clean the inside and perimeter of the seals with a contact cleaner (for example, Maxima Electrical Contact) and regrease under the seal.
9. Fit the new spacers.
10. Spread the pads in the brake calipers to help reposition the wheel.
11. Reinsert the wheels and insert the axles.
12. Reinstall the chain and adjust the tension using the axle adjusters.
13. Tighten the axle nuts to the recommended torque.
14. Once the motorcycle is on its wheels, compress the forks several times to align the tubes, then tighten the pinch bolts.
15. Engage the brakes to realign the calipers.

Specifications:

• v-colour: Silver
• weight (g): 77
• width (mm): 108
• height (mm): 40
• length (mm): 159
• volume (cm³): 687