RFX Rear wheel spacer for motorcycle KTM Pro Series

The RFX Pro Series wheel spacers are lighter and more durable than the original parts.

Made from 7075-T6 aluminium and coloured anodised, they resist surface wear and limit dirt entry into the hub, extending the life of the bearings.

A rear shoulder keeps the spacers attached to the seals, limiting their fall during maintenance and speeding up wheel changes.

Features:

• 7075-T6 aluminium construction
• Coloured anodisation for wear resistance
• CNC machining for reduced tolerances
• Rear shoulder for holding during maintenance

Installation instructions:

1. Place the bike on a lift, with the wheels off the ground.
2. Remove the large axle nut and loosen the pinch bolts at the bottom of the fork clamp.
3. Remove the wheel axle; a brass drift and hammer may be needed if the axle is stuck.
4. The front wheel can then be removed.
5. The rear wheel must be free enough to be pushed forward to release the chain from the sprocket.
6. Remove the rear wheel.
7. Take out the wheel spacers.
8. Clean the inside and around the seals with a contact cleaner (e.g., Maxima Electrical Contact) and re-grease under the seal.
9. Install the new spacers.
10. Spread the pads in the brake calipers to make repositioning the wheel easier.
11. Put the wheels back in place and insert the axles.
12. Reinstall the chain and adjust the tension via the axle adjusters.
13. Tighten the axle nuts to the recommended torque.
14. Once the bike is on its wheels, compress the forks several times to align the tubes, then tighten the pinch bolts.
15. Engage the brakes to realign the calipers.

Specifications:

• colour: Silver
• weight (g): 87
• width (mm): 103
• height (mm): 40
• length (mm): 148
• volume (cm³): 610