RFX Mapping Button OEM Honda

The buttons and switches from the RFX Race series are OEM type replacement parts. They come with the same fittings, fasteners, connectors, and cable lengths as the original part.

Available for a wide range of motorcycles.

• OEM Replacement
• Accepts all original connectors
• OEM cable length

Installation instructions:

• Start by removing the front plate.
• Carefully cut the zip ties holding the start and stop switch cables to the bars, then unscrew the clamps and let them hang.
• Locate the switch connector on the motorcycle, they are often near the steering column on the frame, but sometimes under the tank.
• Detach the connector and remove the switch, noting the routing of the wires.
• Clean the connector with an electrical contact cleaner.
• Lightly attach the new switch to the handlebars at the desired location.
• Route the wires as they were on the old switch and reconnect the connector.
• Check the freedom of movement of the wires by fully turning the handlebars and ensuring the wires are not too tight, adjust if necessary.
• Reposition the zip ties on the wires, placing the cables behind the bars to avoid damage from spills.
• Replace your front plate.

Specifications:

• weight (g): 250
• width (mm): 100
• height (mm): 20
• length (mm): 138
• volume (cm³): 276