RFX Motorcycle starter button Race OEM Honda CRF 250 R

The buttons and switches from the RFX Race series are OEM replacement parts. They come with the same connectors, fasteners, and cable lengths as the original part.

Available for a wide range of motorbikes.

• OEM replacement
• Accepts all original connectors
• OEM cable length

Installation instructions:

• Start by removing the front plate.
• Carefully cut the zip ties holding the start and stop switch cables to the bars, then unscrew the clamps and let them hang.
• Locate the switch connector on the bike, which is often near the steering column on the frame, but sometimes under the tank.
• Detach the connector and remove the switch, noting the routing of the wires.
• Clean the connector with electrical contact cleaner.
• Slightly attach the new switch to the handlebars in the desired position.
• Route the wires as they were on the old switch and reconnect the connector.
• Check the freedom of movement of the wires by turning the handlebars fully and ensuring the wires are not too tight, adjust if necessary.
• Reposition the zip ties on the wires, placing the cables behind the bars to avoid damage from debris.
• Reinstall your front plate.

Specifications:

• weight (g): 49
• width (mm): 100
• height (mm): 33
• length (mm): 132
• volume (cm³): 436