RFX Motorcycle circuit breaker Kawasaki Race Series KX 60 (KX60B)

The RFX Race Series kill switches are OEM replacement parts.

Complete with the same fittings, fasteners, connectors, and cable lengths as the original part.

Available for a wide variety of motorcycles.

Features:

• OEM replacement
• Accepts all original connectors
• OEM cable length

Installation Instructions:

• Start by removing the front plate.
• Carefully cut the cable ties that hold the start and stop switch cables on the handlebars, then unscrew the clamps and let them hang.
• Locate the switch connector on the motorcycle, it is often near the steering head on the frame but can sometimes be found under the tank.
• Detach the connector and remove the switch, noting the wiring path.
• Clean the connector with an electric contact cleaner.
• Lightly attach the new switch to the handlebars in the desired position.
• Route the wires as they were for the old switch and assemble the connector.
• Check that the wires are not tight by turning the handlebars to full extension, adjust if necessary.
• Reinstall the cable ties if possible by positioning the cables at the back of the handlebars to avoid damage from debris.
• Replace your front plate.

Specifications:

• weight (g): 50
• width (mm): 100
• height (mm): 28
• length (mm): 140
• volume (cm³): 392