RFX Motorcycle circuit breaker Kawasaki Race Series KX 250 F (KX252A)

The RFX Race Series cut-off switches are OEM replacement parts.

Complete with the same fittings, fastenings, connectors, and cable lengths as the original part.

Available for a wide variety of bikes.

Features:

• OEM replacement
• Compatible with all original connectors
• OEM cable length

Fitting instructions:

• Start by removing the front plate.
• Carefully cut the cable ties that hold the starter and stop switch cables on the handlebars, then unscrew the clips and let them hang.
• Locate the switch connector on the bike, it is often near the steering column on the frame but can sometimes be under the tank.
• Detach the connector and remove the switch, noting the wiring route.
• Clean the connector with an electrical contact cleaner.
• Lightly attach the new switch to the handlebars in the desired position.
• Route the wires as with the old switch and assemble the connector.
• Check that the wires are not tight by turning the handlebars fully, adjust if necessary.
• Reinstall the cable ties if possible, positioning the cables at the back of the handlebars to avoid damage from debris.
• Put your front plate back in place.

Specifications:

• weight (g): 300
• width (mm): 95
• height (mm): 25
• length (mm): 135
• volume (cm³): 321