RFX Motorcycle circuit breaker Fantic Race Series

The RFX Race Series cut-off switches are OEM replacement parts.

Complete with the same fittings, fixings, connectors, and cable lengths as the original part.

Available for a wide variety of motorcycles.

Features:

• OEM replacement
• Accepts all original connectors
• OEM cable length

Installation instructions:

• Start by removing the front plate.
• Carefully cut the cable ties holding the starter and stop switch cables on the handlebars, then unscrew the clamps and let them hang.
• Locate the switch connector on the motorcycle, it’s usually near the steering column on the frame but can sometimes be found under the fuel tank.
• Detach the connector and remove the switch, noting the routing of the wiring.
• Clean the connector with an electrical contact cleaner.
• Lightly attach the new switch to the handlebars in the desired position.
• Route the wires as with the old switch and assemble the connector.
• Make sure the wires aren’t tight by turning the handlebars to full extension, adjust if necessary.
• Reinstall the cable ties if possible, positioning the cables at the back of the handlebars to avoid damage from debris.
• Replace your front plate.

Specifications:

• weight (g): 500
• width (mm): 95
• height (mm): 25
• length (mm): 145
• volume (cm³): 344