RFX Mapping Button OEM Yamaha

The buttons and switches from the RFX Race series are OEM type replacement parts. They come with the same connectors, fastenings, and cable lengths as the original part.

Available for a wide range of motorcycles.

• OEM replacement
• Accepts all original connectors
• OEM cable length

Fitting instructions:

• Start by removing the front plate.
• Carefully cut the cable ties holding the starting and stop switch cables to the bars, then unscrew the clamps and let them hang.
• Locate the switch connector on the motorcycle; they are often found near the steering column on the frame, but sometimes under the tank.
• Detach the connector and remove the switch, noting the routing of the wires.
• Clean the connector using an electrical contact cleaner.
• Lightly attach the new switch to the handlebars in the desired position.
• Feed the wires as they were on the old switch and reconnect the connector.
• Check the freedom of movement of the wires by turning the handlebars fully and ensuring that the wires are not too tight; adjust if necessary.
• Reposition the cable ties on the wires, placing the cables behind the bars to avoid damage from projections.
• Reattach your front plate.

Specifications:

• weight (g): 400
• width (mm): 110
• height (mm): 20
• length (mm): 240
• volume (cm³): 528