RFX Motorcycle circuit breaker Gas Gas Race Series

The RFX Race Series kill switches are OEM replacement parts.

Complete with the same connectors, fittings, and cable lengths as the original part.

Available for a wide range of motorcycles.

Features:

• OEM replacement
• Accepts all original connectors
• OEM cable length

Installation instructions:

• Start by removing the front plate.
• Carefully cut the cable ties holding the start and stop switch cables on the handlebars, then unscrew the clamps and let them hang.
• Locate the switch connector on the motorcycle, it is often near the steering column on the frame but can sometimes be found under the tank.
• Detach the connector and remove the switch, noting the wiring path.
• Clean the connector with electrical contact cleaner.
• Lightly secure the new switch on the handlebars in the desired position.
• Route the wires as for the old switch and attach the connector.
• Check that the wires are not taut by turning the handlebars fully; adjust if necessary.
• Reinstall the cable ties if possible, positioning the cables at the back of the handlebars to avoid damage from debris.
• Reattach your front plate.

Specifications:

• weight (g): 60
• width (mm): 100
• height (mm): 25
• length (mm): 165
• volume (cm³): 413