Highsider Classic aluminum motorcycle license plate holder

HIGHSIDER AKRON-RS design perfectly matches the lines of your bike.

The HIGHSIDER AKRON-RS model-specific bracket allows mounting on your bike'sorigine mounting points, so replacement is possible without additional drilling or cutting.

HIGHSIDER

To prevent damage to cables, all sharp-edged feed-throughs are protected by a rubber membrane grommet.

The license plate is made of sheet steel, 2 mm thick. Precise laser cutting is used. After the edging always follows the weather-resistant black powder coating.

This guarantees optimum fit and durability.

Thanks to the infinitely variable adjustment, you can bring the plate into the desired position without drilling. To hold the plate in this position, there's an additional locking screw.

The HIGHSIDER AKRON-RS blinker brackets are adjustable in width, making them suitable for all types of accessory indicators. This adjustment option allows you to adapt the position of your indicators to a wide variety of license plates. To enable the indicators to be mounted without separating the wiring harness, the 8 mm holes are slotted on the side.

You can also adjust the reflector position individually via a slider. This makes it easy to adapt to different EU license plate models.

Two rubber washers are included to screw the license plate securely in place and reduce vibration. Another rubber buffer supports the license plate on its underside.

Details :

- model-matched bracket - infinitely adjustable blinker bracket

- split flasher bracket for easy mounting without cable separation

- continuously adjustable reflector, E-approved

- suitable for European license plates

- infinitely adjustable angle of inclination

- additional screw for optimum positional security

- easy mounting without additional work steps (e.g. drilling)

- easy mounting of license plate through oblong holes

Included in delivery of HIGHSIDER AKRON-RS:

- Model-related bracket with mounting parts

- License plate mounting plate HIGHSIDER AKRON-RS

- Adjustable turn signal brackets

- E-tested reflector with adjustable bracket

- Mounting instructions

Notes:

- If side reflectors are fitted to yourorigine license plate mount, these must be re-installed in a suitable position or replaced with new ones.

- Special turn signal brackets are available as an option fororigine turn signals.

Tip:

If you haven't found a license plate bracket specific to your vehicle model, universal license plate brackets from HIGHSIDER, which are available in many different models, are certainly a good alternative.