RFX Front motorcycle wheel spacer Suzuki Pro Series

The RFX Pro Series wheel spacers are lighter and more durable than the original parts.

Made from 7075-T6 aluminium and anodised in colour to increase durability. This reduces surface wear and limits dirt from entering the hub, thereby extending the life of the bearing.

Designed with a rear lip to keep them attached to the seals, which reduces the risk of dropping during maintenance and speeds up wheel changes.

The RFX products are tested and used by many top-level Grand Prix and British Motocross teams.

• 7075-T6 aluminium construction.
• Colour anodising for durability.
• Machined rear positioning lip.

CNC Machined

For tighter tolerances

Installation Instructions

• Start with the bike on a stand, wheels off the ground.
• Remove the main spindle nut and loosen the clamp bolts on the bottom of the fork.
• Remove the wheel spindle; a brass punch and hammer may be required if it is tight.
• The front wheel can now be removed.
• The rear wheel should now be loose enough to push forward and lift the chain off the rear sprocket.
• The rear wheel can now be removed.
• Remove the wheel spacers.
• Clean around the seals with a contact cleaner such as Maxima Electrical Contact and re-grease under the seal.
• Install the new wheel spacers.
• Spread the brake pads inside the calipers to make reinstallation of the wheel easier.
• Reinstall the wheels and insert the spindles.
• Reconnect the chain and adjust the correct tension by adjusting the axle adjusters.
• Tighten the main spindle nuts to the correct torque.
• Bike off the stand, pump the forks

Features:

• v-colour: Black
• weight (g): 74
• width (mm): 116
• height (mm): 40
• length (mm): 175
• volume (cm³): 812