RFX Rear wheel spacer for motorcycle Suzuki Pro Series

The RFX Pro Series wheel spacers are lighter and more durable than original parts.

Made from 7075-T6 aluminium and coloured anodised, they resist surface wear and limit dirt entry into the hub, extending the life of the bearings.

A rear shoulder keeps the spacers attached to the seals, preventing them from falling out during maintenance and speeding up wheel changes.

Features:

• 7075-T6 aluminium construction
• Coloured anodising for wear resistance
• CNC machining for reduced tolerances
• Rear shoulder for retention during maintenance

Installation instructions:

1. Place the bike on a motorcycle lift, with the wheels off the ground.
2. Remove the large axle nut and loosen the pinch bolts at the bottom of the fork clamp.
3. Remove the wheel axle; a brass drift and hammer may be needed if the axle is stuck.
4. The front wheel can then be removed.
5. The rear wheel should be free enough to be pushed forward to release the chain from the sprocket.
6. Remove the rear wheel.
7. Take out the wheel spacers.
8. Clean the inside and the circumference of the seals with a contact cleaner (e.g. Maxima Electrical Contact) and re-grease under the seal.
9. Fit the new spacers.
10. Spread the pads in the brake calipers to ease repositioning of the wheel.
11. Reinstall the wheels and insert the axles.
12. Reconnect the chain and adjust tension using the axle adjusters.
13. Tighten the axle nuts to the recommended torque.
14. Once the bike is on its wheels, compress the forks several times to align the tubes, then tighten the pinch bolts.
15. Engage the brakes to realign the calipers.

Specifications:

• colour: Yellow
• material: Aluminium
• v-colour: Yellow
• weight (g): 50
• width (mm): 115
• height (mm): 40
• length (mm): 170
• volume (cm³): 782