RFX Front motorcycle wheel spacer Honda Pro Series

The RFX Pro Series wheel spacers are lighter and more durable than the original parts.

Made from 7075-T6 aluminium and anodised in colour to increase durability. This reduces surface wear and limits dirt from entering the hub, therefore extending the life of the bearing.

Designed with a rear lip to keep them secured to the seals, this reduces the risk of falling off during maintenance and speeds up wheel changes.

The RFX products are tested and used by numerous high-level Grand Prix and British Motocross teams.

• 7075-T6 aluminium construction.
• Colour anodising for durability.
• Machined rear positioning lip.

CNC Machined

For tighter tolerances

Mounting Instructions

• Start with the bike on a stand, wheels off the ground.
• Remove the main spindle nut and loosen the clamp bolts at the bottom of the fork.
• Remove the wheel spindle, a brass punch and hammer may be needed if tight.
• The front wheel can now be removed.
• The rear wheel should now be loose enough to push forward and lift the chain off the rear sprocket.
• The rear wheel can now be removed.
• Remove the wheel spacers.
• Clean around the seals with a contact cleaner like Maxima Electrical Contact and re-grease under the seal.
• Install the new wheel spacers.
• Spread the brake pads inside the calipers to make it easier to refit the wheel.
• Reinstall the wheels and insert the spindles.
• Refit the chain and adjust the proper tension by adjusting the axle adjusters.
• Tighten the main spindle nuts to the correct torque.
• Bike off the stand, pump the forks.

Specifications:

• colour: Black
• weight (g): 50
• width (mm): 116
• height (mm): 40
• length (mm): 175
• volume (cm³): 812