RFX Front motorcycle wheel spacer Honda Pro Series

The RFX Pro Series wheel spacers are lighter and more durable than the original parts.

Made from 7075-T6 aluminium and anodised in colour to enhance durability. This reduces surface wear and limits dirt penetration into the hub, thereby extending the bearing life.

Designed with a rear lip to keep them attached to the seals, this reduces the risk of falling off during maintenance and speeds up wheel changes.

The RFX products are tested and used by many top-level British Grand Prix and Motocross teams.

• 7075-T6 aluminium construction.
• Colour anodisation for durability.
• Machined rear positioning lip.

CNC Machined

For tighter tolerances.

Installation Instructions

• Start with the bike on a stand, wheels off the ground.
• Remove the main spindle nut and loosen the pinch bolts at the bottom of the fork.
• Remove the wheel spindle; a brass punch and hammer may be needed if it's tight.
• The front wheel can now be removed.
• The rear wheel should now be loose enough to push forward and lift the chain off the rear sprocket.
• The rear wheel can now be removed.
• Remove the wheel spacers.
• Clean around the seals with a contact cleaner such as Maxima Electrical Contact and regrease under the seal.
• Install the new wheel spacers.
• Push the brake pads apart inside the calipers to facilitate wheel replacement.
• Reinstall the wheels and insert the spindles.
• Reinstall the chain and set the appropriate tension by adjusting the axle spacers.
• Tighten the main spindle nuts to the appropriate torque.
• Bike off the stand, pump the forks.

Features:

• Colour: Silver
• Weight (g): 50
• Width (mm): 116
• Height (mm): 40
• Length (mm): 175
• Volume (cm³): 812