RFX Rear wheel spacer for motorcycle Suzuki Pro Series

The wheel spacers RFX Pro Series are lighter and more durable than the original parts.

Made from 7075-T6 aluminium and anodised in colour, they resist surface wear and limit dirt entry into the hub, extending the lifespan of the bearings.

A rear shoulder keeps the spacers attached to the seals, preventing them from falling during maintenance tasks and speeding up wheel changes.

Features:

• 7075-T6 aluminium construction
• Colour anodisation for wear resistance
• CNC machining for tighter tolerances
• Rear shoulder for maintenance support

Installation instructions:

1. Place the bike on a bike lift, with wheels off the ground.
2. Remove the large axle nut and loosen the pinch bolts on the bottom of the fork yoke.
3. Remove the wheel axle; a brass drift and hammer may be needed if the axle is stuck.
4. The front wheel can then be taken off.
5. The rear wheel should be free enough to be pushed forward and release the chain from the sprocket.
6. Remove the rear wheel.
7. Take out the wheel spacers.
8. Clean the inside and edges of the seals with a contact cleaner (for example, Maxima Electrical Contact) and re-grease under the seal.
9. Fit the new spacers.
10. Spread the brake pads in the calipers to make repositioning the wheel easier.
11. Put the wheels back in place and insert the axles.
12. Reinstall the chain and adjust the tension using the axle tensioners.
13. Tighten the axle nuts to the recommended torque.
14. Once the bike is on its wheels, compress the forks several times to align the tubes, then tighten the pinch bolts.
15. Engage the brakes to realign the calipers.

Specifications:

• v-colour: Black
• weight (g): 70
• width (mm): 111
• height (mm): 43
• length (mm): 150
• volume (cm³): 716