RFX Rear wheel spacer for motorcycle Suzuki Pro Series

The RFX Pro Series wheel spacers are lighter and more durable than original parts.

Made from 7075-T6 aluminium and anodised in colour, they resist surface wear and limit dirt entry into the hub, extending the lifespan of the bearings.

A rear shoulder keeps the spacers attached to the seals, reducing the risk of them falling during maintenance and speeding up wheel changes.

Features:

• 7075-T6 aluminium construction
• Colour anodising for wear resistance
• CNC machining for reduced tolerances
• Rear shoulder to hold during maintenance

Installation instructions:

1. Place the bike on a motorcycle lift, with the wheels off the ground.
2. Remove the large axle nut and loosen the pinch screws on the bottom of the fork yoke.
3. Remove the wheel axle; a brass punch and a hammer may be needed if the axle is stuck.
4. The front wheel can then be taken off.
5. The rear wheel must be free enough to push forward and release the chain from the sprocket.
6. Remove the rear wheel.
7. Take off the wheel spacers.
8. Clean the inside and around the seals with a contact cleaner (e.g., Maxima Electrical Contact) and re-grease under the seal.
9. Install the new spacers.
10. Spread the pads in the brake calipers to help reposition the wheel.
11. Reinstall the wheels and insert the axles.
12. Reattach the chain and adjust the tension via the axle adjusters.
13. Tighten the axle nuts to the recommended torque.
14. Once the bike is on its wheels, compress the forks several times to align the tubes, then tighten the pinch screws.
15. Engage the brakes to realign the calipers.

Specifications:

• v-colour: Silver
• weight (g): 69
• width (mm): 120
• height (mm): 46
• length (mm): 175
• volume (cm³): 966