RFX Rear wheel spacer for motorcycle Suzuki Pro Series

The RFX Pro Series wheel spacers are lighter and more durable than the original parts.

Made from 7075-T6 aluminium and anodized in colour, they resist surface wear and limit dirt entering the hub, extending the life of the bearings.

A rear shoulder keeps the spacers attached to the seals, preventing them from falling during maintenance and speeding up wheel changes.

Features:

• Construction from 7075-T6 aluminium
• Colour anodizing for wear resistance
• CNC machining for reduced tolerances
• Rear shoulder support during maintenance

Installation instructions:

1. Place the motorcycle on a bike lift, with the wheels off the ground.
2. Remove the large axle nut and loosen the pinch bolts at the bottom of the fork clamp.
3. Pull the wheel axle out; a brass punch and hammer may be needed if the axle is stuck.
4. The front wheel can then be removed.
5. The rear wheel should be free enough to be pushed forward to release the chain from the sprocket.
6. Remove the rear wheel.
7. Take off the wheel spacers.
8. Clean the inside and outer area of the seals with contact cleaner (for example, Maxima Electrical Contact) and re-grease under the seal.
9. Install the new spacers.
10. Spread the pads in the brake calipers to help reposition the wheel.
11. Replace the wheels and insert the axles.
12. Reattach the chain and adjust the tension using the axle adjusters.
13. Tighten the axle nuts to the recommended torque.
14. Once the motorcycle is on its wheels, compress the fork several times to align the tubes, then tighten the pinch bolts.
15. Engage the brakes to realign the calipers.

Features:

• Colour: Black
• Material: Aluminium
• V-colour: Black
• Weight (g): 81
• Width (mm): 109
• Height (mm): 40
• Length (mm): 161
• Volume (cm³): 702