RFX Rear wheel spacer for motorcycle Suzuki Pro Series

The RFX Pro Series wheel spacers are lighter and more durable than original parts.

Made from 7075-T6 aluminium and anodised in colour, they resist surface wear and limit dirt ingress into the hub, extending the life of the bearings.

A rear shoulder keeps the spacers attached to the seals, preventing them from falling out during maintenance and speeding up wheel changes.

Features:

• 7075-T6 aluminium construction
• Colour anodisation for wear resistance
• CNC machining for reduced tolerances
• Rear shoulder for retention during maintenance

Installation Instructions:

1. Place the motorcycle on a bike lift, with the wheels off the ground.
2. Remove the large axle nut and loosen the pinch bolts on the bottom of the fork yoke.
3. Remove the wheel axle; a brass drift and hammer may be needed if the axle is stuck.
4. The front wheel can then be removed.
5. The rear wheel should be loose enough to push forward and free the chain from the sprocket.
6. Remove the rear wheel.
7. Take out the wheel spacers.
8. Clean the inside and edges of the seals with a contact cleaner (e.g. Maxima Electrical Contact) and re-grease under the seal.
9. Install the new spacers.
10. Spread the pads in the brake calipers to aid in repositioning the wheel.
11. Replace the wheels and insert the axles.
12. Reattach the chain and adjust the tension using the axle adjusters.
13. Tighten the axle nuts to the specified torque.
14. Once the motorcycle is on its wheels, compress the fork several times to align the tubes, then tighten the pinch bolts.
15. Engage the brakes to realign the calipers.

Specifications:

• colour: Silver
• material: Aluminium
• v-colour: Silver
• weight (g): 83
• width (mm): 107
• height (mm): 40
• length (mm): 158
• volume (cm³): 676