RFX Rear wheel spacer for motorcycle Pro Series

The wheel spacers RFX Pro Series are lighter and more durable than the original parts.

Made from 7075-T6 aluminium and anodised in colour, they resist surface wear and limit dirt entry into the hub, extending the life of the bearings.

A rear shoulder keeps the spacers attached to the seals, preventing them from falling off during maintenance and speeding up wheel changes.

Features:

• 7075-T6 aluminium construction
• Colour anodising for wear resistance
• CNC machining for tighter tolerances
• Rear shoulder to hold during maintenance

Assembly instructions:

1. Place the bike on a motorcycle lift, with the wheels off the ground.
2. Remove the large axle nut and loosen the pinch bolts at the bottom of the fork clamps.
3. Extract the wheel axle; a brass punch and hammer may be needed if the axle is stuck.
4. The front wheel can then be removed.
5. The rear wheel must be free enough to push forward and release the chain from the sprocket.
6. Remove the rear wheel.
7. Take out the wheel spacers.
8. Clean the inside and around the seals with contact cleaner (e.g., Maxima Electrical Contact) and re-grease under the seal.
9. Install the new spacers.
10. Push the brake pads in the calipers to make repositioning the wheel easier.
11. Reinstall the wheels and insert the axles.
12. Reattach the chain and adjust the tension using the axle adjusters.
13. Tighten the axle nuts to the recommended torque.
14. Once the bike is on its wheels, compress the forks several times to align the tubes, then tighten the pinch bolts.
15. Apply the brakes to realign the calipers.

Specifications:

• colour: Red
• material: Aluminium
• v-colour: Red
• weight (g): 50
• width (mm): 115
• height (mm): 40
• length (mm): 170
• volume (cm³): 782