RFX Rear wheel spacer for motorcycle Pro Series

The wheel spacers RFX Pro Series are lighter and more durable than the original parts.

Made from 7075-T6 aluminium and colour anodised, they resist surface wear and help keep dirt out of the hub, extending the life of the bearings.

A rear shoulder keeps the spacers attached to the seals, preventing them from dropping during maintenance and speeding up wheel changes.

Features:

• 7075-T6 aluminium construction
• Colour anodising for wear resistance
• CNC machining for reduced tolerances
• Rear shoulder to hold during maintenance

Installation instructions:

1. Place the bike on a lift, wheels off the ground.
2. Remove the large axle nut and loosen the pinch bolts at the bottom of the fork clamp.
3. Pull the wheel axle out; a brass drift and hammer may be needed if the axle is stuck.
4. The front wheel can then be removed.
5. The rear wheel should be free enough to push forward to release the chain from the sprocket.
6. Remove the rear wheel.
7. Take out the wheel spacers.
8. Clean the inside and the edges of the seals with contact cleaner (for example, Maxima Electrical Contact) and re-grease under the seal.
9. Install the new spacers.
10. Spread the pads in the brake calipers to ease the repositioning of the wheel.
11. Put the wheels back in place and insert the axles.
12. Reattach the chain and adjust the tension using the axle adjusters.
13. Tighten the axle nuts to the recommended torque.
14. Once the bike is on its wheels, compress the forks several times to align the tubes, then tighten the pinch bolts.
15. Operate the brakes to realign the calipers.

Specifications:

• colour: Blue
• material: Aluminium
• v-colour: Blue
• weight (g): 100
• width (mm): 115
• height (mm): 30
• length (mm): 170
• volume (cm³): 587