RFX Rear wheel spacer for motorcycle Pro Series

The wheel spacers RFX Pro Series are lighter and more durable than the original parts.

Made from 7075-T6 aluminium and coloured anodised, they resist surface wear and limit dirt getting into the hub, extending the life of the bearings.

A rear shoulder keeps the spacers attached to the seals, preventing them from falling off during maintenance and speeding up wheel changes.

Features:

• 7075-T6 aluminium construction
• Coloured anodisation for wear resistance
• CNC machining for tighter tolerances
• Rear shoulder to keep them in place during maintenance

Installation Instructions:

1. Place the bike on a bike stand, with wheels off the ground.
2. Remove the large axle nut and loosen the pinch bolts at the bottom of the fork yoke.
3. Extract the wheel axle; a brass drift and hammer may be needed if the axle is seized.
4. The front wheel can then be removed.
5. The rear wheel must be free enough to be pushed forward to release the chain from the sprocket.
6. Remove the rear wheel.
7. Take out the wheel spacers.
8. Clean the inside and around the seals with contact cleaner (for example, Maxima Electrical Contact) and re-grease under the seal.
9. Install the new spacers.
10. Spread the pads in the brake calipers to make repositioning the wheel easier.
11. Replace the wheels and insert the axles.
12. Reattach the chain and adjust the tension via the axle adjusters.
13. Tighten the axle nuts to the recommended torque.
14. Once the bike is on its wheels, compress the forks several times to align the tubes, then tighten the pinch bolts.
15. Activate the brakes to realign the calipers.

Specifications:

• colour: Red
• material: Aluminium
• v-colour: Red
• weight (g): 50
• width (mm): 116
• height (mm): 40
• length (mm): 175
• volume (cm³): 812