RFX Rear wheel spacer for motorcycle Pro Series

The wheel spacers RFX Pro Series are lighter and more durable than the original parts.

Made from 7075-T6 aluminium and anodised in colour, they resist surface wear and limit dirt getting into the hub, extending the life of the bearings.

A rear shoulder keeps the spacers attached to the seals, preventing them from falling during maintenance and speeding up wheel changes.

Features:

• 7075-T6 aluminium construction
• Colour anodising for wear resistance
• CNC machining for tighter tolerances
• Rear shoulder for holding during maintenance

Mounting Instructions:

1. Place the motorcycle on a lift, with the wheels off the ground.
2. Remove the large axle nut and loosen the pinch bolts at the bottom of the fork clamp.
3. Remove the wheel axle; a brass drift and hammer may be needed if the axle is stuck.
4. The front wheel can then be removed.
5. The rear wheel must be free enough to be pushed forward to release the chain from the sprocket.
6. Remove the rear wheel.
7. Take out the wheel spacers.
8. Clean the inside and around the seals with a contact cleaner (for example, Maxima Electrical Contact) and regrease under the seal.
9. Fit the new spacers.
10. Spread the pads in the brake calipers to help reposition the wheel.
11. Replace the wheels and insert the axles.
12. Reattach the chain and adjust the tension via the axle adjusters.
13. Tighten the axle nuts to the recommended torque.
14. Once the motorcycle is on its wheels, compress the forks several times to align the tubes, then tighten the pinch bolts.
15. Activate the brakes to realign the calipers.

Specifications:

• colour: Green
• material: Aluminium
• v-colour: Green
• weight (g): 50
• width (mm): 115
• height (mm): 40
• length (mm): 170
• volume (cm³): 782