RFX Rear wheel spacer for motorcycle Pro Series

The wheel spacers RFX Pro Series are lighter and more durable than the original parts.

Made from 7075-T6 aluminium and colour anodised, they resist surface wear and limit dirt entry into the hub, extending the life of the bearings.

A rear shoulder keeps the spacers attached to the seals, reducing the risk of them dropping during maintenance and speeding up wheel changes.

Features:

• Construction in 7075-T6 aluminium
• Colour anodisation for wear resistance
• CNC machining for reduced tolerances
• Rear shoulder for retention during maintenance

Installation instructions:

1. Place the bike on a lift, with the wheels off the ground.
2. Remove the large axle nut and loosen the pinch bolts at the bottom of the fork clamp.
3. Remove the wheel axle; a brass punch and a hammer may be needed if the axle is stuck.
4. The front wheel can then be removed.
5. The rear wheel must be free enough to be pushed forward to release the chain from the sprocket.
6. Remove the rear wheel.
7. Take off the wheel spacers.
8. Clean the inside and around the seals with a contact cleaner (for example, Maxima Electrical Contact) and re-grease under the seal.
9. Install the new spacers.
10. Spread the pads in the brake calipers to aid in repositioning the wheel.
11. Put the wheels back in place and insert the axles.
12. Reattach the chain and adjust the tension using the axle adjusters.
13. Tighten the axle nuts to the recommended torque.
14. Once the bike is on its wheels, compress the fork several times to align the tubes, then tighten the pinch bolts.
15. Engage the brakes to realign the calipers.

Specifications:

• colour: Orange
• weight (g): 100
• width (mm): 115
• height (mm): 30
• length (mm): 170
• volume (cm³): 587