RFX Rear wheel spacer for motorcycle Pro Series

The wheel spacers RFX Pro Series are lighter and more durable than the original parts.

Made from 7075-T6 aluminium and coloured anodised, they resist surface wear and limit dirt entry into the hub, extending the life of the bearings.

A rear shoulder keeps the spacers attached to the seals, preventing them from falling out during maintenance and speeding up wheel changes.

Features:

• 7075-T6 aluminium construction
• Coloured anodising for wear resistance
• CNC machining for tighter tolerances
• Rear shoulder to hold in place during maintenance

Installation instructions:

1. Place the bike on a lift with the wheels off the ground.
2. Remove the large axle nut and loosen the pinch bolts on the bottom of the fork yoke.
3. Remove the wheel axle; a brass drift and hammer may be needed if the axle is stuck.
4. The front wheel can then be removed.
5. The rear wheel should be free enough to slide forward and release the chain from the sprocket.
6. Remove the rear wheel.
7. Take out the wheel spacers.
8. Clean the inside and around the seals with a contact cleaner (e.g. Maxima Electrical Contact) and re-grease under the seal.
9. Install the new spacers.
10. Push the brake pads in the calipers to assist with repositioning the wheel.
11. Put the wheels back in place and insert the axles.
12. Reinstall the chain and adjust the tension using the axle adjusters.
13. Tighten the axle nuts to the recommended torque.
14. Once the bike is on its wheels, compress the forks several times to align the tubes, then tighten the pinch bolts.
15. Operate the brakes to realign the calipers.

Specifications:

• colour: Blue
• material: Aluminium
• v-colour: Blue
• weight (g): 50
• width (mm): 115
• height (mm): 40
• length (mm): 170
• volume (cm³): 782