RFX Rear wheel spacer for motorcycle Pro Series

The wheel spacers RFX Pro Series are lighter and more durable than the original parts.

Made from 7075-T6 aluminium and colour anodised, they resist surface wear and limit dirt entry into the hub, extending the life of the bearings.

A rear shoulder keeps the spacers attached to the seals, preventing them from falling out during maintenance and speeding up wheel changes.

Features:

• 7075-T6 aluminium construction
• Colour anodisation for wear resistance
• CNC machining for reduced tolerances
• Rear shoulder for maintenance support

Installation Instructions:

1. Place the motorcycle on a lift, with wheels off the ground.
2. Remove the large axle nut and loosen the pinch bolts on the bottom of the fork clamp.
3. Pull out the wheel axle; a brass drift and hammer may be needed if the axle is stuck.
4. The front wheel can then be removed.
5. The rear wheel should be free enough to push forward and release the chain from the sprocket.
6. Remove the rear wheel.
7. Take out the wheel spacers.
8. Clean the inside and around the seals with a contact cleaner (e.g., Maxima Electrical Contact) and re-grease underneath the seal.
9. Install the new spacers.
10. Spread the pads in the brake calipers to make repositioning the wheel easier.
11. Put the wheels back in place and insert the axles.
12. Reattach the chain and adjust the tension via the axle adjusters.
13. Tighten the axle nuts to the specified torque.
14. Once the motorcycle is on its wheels, compress the fork several times to align the tubes, then tighten the pinch bolts.
15. Engage the brakes to realign the calipers.

Features:

• v-colour: Silver
• weight (g): 81
• width (mm): 116
• height (mm): 40
• length (mm): 175
• volume (cm³): 812