RFX Rear wheel spacer for motorcycle Pro Series

The wheel spacers RFX Pro Series are lighter and more durable than the original parts.

Made from 7075-T6 aluminium and anodised in colour, they resist surface wear and limit dirt getting into the hub, extending the life of the bearings.

A rear shoulder keeps the spacers attached to the seals, to prevent them from falling during maintenance and to speed up wheel changes.

Features:

• Construction in 7075-T6 aluminium
• Colour anodisation for wear resistance
• CNC machined for reduced tolerances
• Rear shoulder for support during maintenance

Installation instructions:

1. Place the bike on a lift, with the wheels off the ground.
2. Remove the large axle nut and loosen the pinch bolts at the bottom of the fork crown.
3. Pull out the wheel axle; a brass drift and hammer may be needed if the axle is stuck.
4. The front wheel can then be removed.
5. The rear wheel should be free to push forward and release the chain from the sprocket.
6. Remove the rear wheel.
7. Remove the wheel spacers.
8. Clean the inside and around the seals with a contact cleaner (e.g., Maxima Electrical Contact) and re-grease under the seal.
9. Install the new spacers.
10. Spread the pads in the brake calipers to make repositioning the wheel easier.
11. Replace the wheels and insert the axles.
12. Reinstall the chain and adjust the tension via the axle adjusters.
13. Tighten the axle nuts to the recommended torque.
14. Once the bike is on its wheels, compress the forks several times to align the tubes, then tighten the pinch bolts.
15. Operate the brakes to realign the calipers.

Specifications:

• Colour: Black
• Weight (g): 82
• Width (mm): 117
• Height (mm): 40
• Length (mm): 175
• Volume (cm³): 819