RFX Rear wheel spacer for motorcycle Pro Series

The wheel spacers RFX Pro Series are lighter and more durable than the original parts.

Made from 7075-T6 aluminium and anodised in colour, they resist surface wear and limit dirt entry into the hub, prolonging the life of the bearings.

A rear shoulder keeps the spacers attached to the seals, preventing them from falling during maintenance and speeding up wheel changes.

Features:

• 7075-T6 aluminium construction
• Colour anodisation for wear resistance
• CNC machining for tighter tolerances
• Rear shoulder for securing during maintenance

Installation Instructions:

1. Place the bike on a lift, with the wheels off the ground.
2. Remove the large axle nut and loosen the pinch bolts on the bottom of the fork clamp.
3. Extract the wheel axle; a brass drift and hammer may be needed if the axle is stuck.
4. The front wheel can then be removed.
5. The rear wheel should be free enough to push forward to release the chain from the sprocket.
6. Remove the rear wheel.
7. Take off the wheel spacers.
8. Clean the inside and around the seals with a contact cleaner (e.g., Maxima Electrical Contact) and re-grease under the seal.
9. Install the new spacers.
10. Wedge the brake pads in the calipers to help reposition the wheel.
11. Put the wheels back in place and insert the axles.
12. Reattach the chain and adjust the tension via the axle adjusters.
13. Tighten the axle nuts to the recommended torque.
14. Once the bike is on its wheels, compress the forks several times to align the tubes, then tighten the pinch bolts.
15. Engage the brakes to realign the calipers.

Specifications:

• colour: Black
• weight (g): 102
• width (mm): 111
• height (mm): 43
• length (mm): 166
• volume (cm³): 792