RFX Rear wheel spacer for motorcycle Pro Series

The wheel spacers RFX Pro Series are lighter and more durable than the original parts.

Made from 7075-T6 aluminium and anodised in colour, they resist surface wear and limit dirt entry into the hub, extending the life of the bearings.

A rear shoulder keeps the spacers attached to the seals, helping to prevent them from dropping during maintenance and speeding up wheel changes.

Features:

• 7075-T6 aluminium construction
• Colour anodisation for wear resistance
• CNC machining for tighter tolerances
• Rear shoulder to hold during maintenance

Installation Instructions:

1. Place the bike on a bike lift, with wheels off the ground.
2. Remove the large axle nut and loosen the pinch bolts on the bottom of the fork clamp.
3. Pull the wheel axle out; a brass punch and hammer may be needed if the axle is stuck.
4. The front wheel can then be removed.
5. The rear wheel should be free enough to be pushed forward to release the chain from the sprocket.
6. Remove the rear wheel.
7. Take out the wheel spacers.
8. Clean the inside and around the seals with a contact cleaner (e.g., Maxima Electrical Contact) and re-grease under the seal.
9. Install the new spacers.
10. Disperse the brake pads in the calipers to ease wheel repositioning.
11. Put the wheels back in place and insert the axles.
12. Reinstall the chain and adjust the tension using the axle adjusters.
13. Tighten the axle nuts to the recommended torque.
14. Once the bike is on its wheels, compress the forks several times to align the tubes, then tighten the pinch bolts.
15. Operate the brakes to realign the calipers.

Specifications:

• colour: Black
• weight (g): 113
• width (mm): 117
• height (mm): 40
• length (mm): 175
• volume (cm³): 819